From LedHed's Wiki
| Line 30: | Line 30: | ||
| − | == Show Neighboring Devices == | + | === Show Neighboring Devices === |
show lldp info remote | show lldp info remote | ||
or | or | ||
| Line 36: | Line 36: | ||
| − | == Save Running Configuration to Startup Config == | + | === Save Running Configuration to Startup Config === |
write mem | write mem | ||
Revision as of 20:24, 12 April 2016
Contents
Commands
Show Running Configuration
show Run sh run
Enter the configuration terminal
config term conf t
Configure VLAN 10
vlan 10
Set port 7 UnTagged on VLAN 1
vlan 10 untag 7
Get MAC Address on port 7
show mac-address 7
or
show arp
Show MAC Table
show mac-address
Show Neighboring Devices
show lldp info remote
or
show cdp neighbors
Save Running Configuration to Startup Config
write mem
Reference
http://blog.petrilopia.net/info/hp-procurve-cli-cheatsheet-2/