From LedHed's Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 30: | Line 30: | ||
| − | == Show Neighboring Devices == | + | === Show Neighboring Devices === |
show lldp info remote | show lldp info remote | ||
or | or | ||
| Line 36: | Line 36: | ||
| − | == Save Running Configuration to Startup Config == | + | === Save Running Configuration to Startup Config === |
write mem | write mem | ||
| + | |||
| + | |||
| + | == God Mode == | ||
| + | edomtset | ||
| + | edomtset | ||
| + | |||
| + | This enables the diagnostic command set | ||
== Reference == | == Reference == | ||
http://blog.petrilopia.net/info/hp-procurve-cli-cheatsheet-2/ | http://blog.petrilopia.net/info/hp-procurve-cli-cheatsheet-2/ | ||
| + | |||
| + | http://evilrouters.net/2010/04/06/hidden-procurve-commands/ | ||
http://community.hpe.com/t5/ProCurve-ProVision-Based/Finding-IP-Addresses-of-Devices-Connected-to-5406zl-Switch-Ports/td-p/5905805 | http://community.hpe.com/t5/ProCurve-ProVision-Based/Finding-IP-Addresses-of-Devices-Connected-to-5406zl-Switch-Ports/td-p/5905805 | ||
Latest revision as of 05:59, 12 May 2016
Contents
Commands
Show Running Configuration
show Run sh run
Enter the configuration terminal
config term conf t
Configure VLAN 10
vlan 10
Set port 7 UnTagged on VLAN 1
vlan 10 untag 7
Get MAC Address on port 7
show mac-address 7
or
show arp
Show MAC Table
show mac-address
Show Neighboring Devices
show lldp info remote
or
show cdp neighbors
Save Running Configuration to Startup Config
write mem
God Mode
edomtset edomtset
This enables the diagnostic command set
Reference
http://blog.petrilopia.net/info/hp-procurve-cli-cheatsheet-2/