From LedHed's Wiki
| (6 intermediate revisions by the same user not shown) | |||
| Line 9: | Line 9: | ||
zpool add | zpool add | ||
| − | zpool status | + | zpool status -v <POOL_NAME> |
zpool list | zpool list | ||
| + | '''Remove a failed disk''' | ||
| + | zpool offline <POOL_NAME> /dev/gptid/00000000-0000-0000-0000-000000000000 | ||
| + | '''Replace Offline disk with new''' | ||
| + | zpool replace <POOL_NAME> /dev/gptid/00000000-0000-0000-0000-000000000000 /dev/da# | ||
| + | ''Note:/dev/da# should be the new disk'' | ||
| + | === io statistics === | ||
| + | zpool iostat mypool 30 | ||
| + | This will display the IO statistics of the pool every seconds. | ||
| + | |||
| + | |||
| + | |||
| + | == ZFS Usage == | ||
| + | |||
| + | === Create ZVOL === | ||
| + | zfs create -V <VOLUME_SIZE> <VOLUME_PATH> | ||
| + | zfs create -V 200g mypool/myvol | ||
| + | |||
| + | === Grow a ZVOL === | ||
| + | zfs set volsize=200G mypool/myvol | ||
| + | ''Note: If using FreeNAS and the ZVOL is an iSCSI extent then you need to open and re-save the extent. This reloads the configuration for the iSCSI service and makes the changes visible to the initiators (VMWare, Windows, etc...)'' | ||
| Line 23: | Line 43: | ||
| − | [[Category:ZFS]] | + | [[Category:ZFS]][[Category:FreeNAS]] |
Latest revision as of 04:06, 10 August 2015
ZPool Usage
zpool create <POOL_NAME> <RAID_LEVEL> <DEVICE>
zpool create mypool raidz da{0,1,2}
zpool destroy <poolname> zpool destroy mypool
zpool add
zpool status -v <POOL_NAME>
zpool list
Remove a failed disk
zpool offline <POOL_NAME> /dev/gptid/00000000-0000-0000-0000-000000000000
Replace Offline disk with new
zpool replace <POOL_NAME> /dev/gptid/00000000-0000-0000-0000-000000000000 /dev/da#
Note:/dev/da# should be the new disk
io statistics
zpool iostat mypool 30
This will display the IO statistics of the pool every seconds.
ZFS Usage
Create ZVOL
zfs create -V <VOLUME_SIZE> <VOLUME_PATH> zfs create -V 200g mypool/myvol
Grow a ZVOL
zfs set volsize=200G mypool/myvol
Note: If using FreeNAS and the ZVOL is an iSCSI extent then you need to open and re-save the extent. This reloads the configuration for the iSCSI service and makes the changes visible to the initiators (VMWare, Windows, etc...)
Reference
zpools man page - http://www.manpagez.com/man/8/zpool/