Difference between revisions of "ESXi iSCSI Tweaks"

Revision as of 23:32, 29 November 2012

iSCSI Initiator Settings

Network Configuration

1. Create a single vSwitch with the NICs you want to use for iSCSI and set them as "Unused Adapters" in the NIC Teaming tab.

2. Create a "vmkernel" for each NIC and override the Teaming Settings, moving only a single NIC to "Active Adapters for each ".

3. Now that we have a properly configured vSwitch, we can bind the vmkernels to the iSCSI Initiator.

Dynamic Discovery

DON'T USE IT!
Dynamic Discovery can seriously increase ESXi's boot time because it has to rediscover each of the dynamic iSCSI connections, and if iSCSI isn't available, then you have to wait for each dynamic iSCSI link to timeout.

At most use it to discover the IQN of your target then remove it.
Once you have the IQN create Static Discoveries.

Managing Paths

1. Right Click your device and select "Manage Paths".

2. Configure Round Robin (Don't forget to click CHANGE).

Taking Advantage of Round Robin

By default ESXi is set to send 1000 IO's through each path before utilizing another path.
If you want a performance boost from Round Robin you can lower the default value.
I haven't found a way to do this from within the vSphere client so you will have to dive into the CLI.
SSH into your VHost and run the following commands:

Get a device list:

esxcli storage nmp device list

Your device may look something like this:

t10.Nexenta_iSCSI_Disk______0024977cf719012_________________

Change the default setting for your chosen device:

esxcli storage nmp psp roundrobin deviceconfig set --cfgfile --type=iops --iops=1 --device=[DEVICENAME]

Where [DEVICENAME] is the name if the device you got in the previous command "t10.Nexenta_iSCSI_Disk______0024977cf719012_________________"
--iops=1 is the number of IO's you want to send down each path before switching to the next path. (I recommend between 1 and 10)

Disable Delayed Acknowledgement

Go to the iSCSI Software Adapter properties.
On the General tab, click "Advanced".
Scroll to the bottom and uncheck "DelayedACK"

Advanced Settings

1. Go to the Configuration tab, then click "Advanced Settings"

2. Click "Disk" then set the following options (scroll to the bottom).

Disk.UseDeviceReset = 0
Disk.UseLunReset = 1

3. Disable VIAA (Hardware Accelerated Locking) by clicking "VMFS3" and setting the following options.

DataMover.HardwareAcceleratedInit = 0
DataMover.HardwareAcceleratedMove= 0 
VMFS3.HardwareAcceleratedLocking = 0

4. Disable UNMAP.

VMFS3.EnableBlockDelete = 0

Note: This may already be disabled on ESXi 5.0u1 and later